thats sounds impressive James, cantwait to see the finished article.

thats sounds impressive James, cantwait to see the finished article.

It really is a cool bit of kit.

Anyone know what OBD II Protocol a 2005 ford focus 2.0TDCi uses? Or even how I can find out? Im guessing its either PWM or CANSF as these are the only two ford related protocol's I can find on there site.

Cant wait for the pod to arrive now.

Just a quick couple of snaps of the unit next to car key for idea of size.

Top:

ST gauge pod is here, not too happy, part of the guage pod is missing.

Theres a rounded part that sits over the front top half of the gauges thats missing :( Really angry as it means im going to have to buy another pod just for that one small part..

This is the part thats missing :

ST gauge pod is here, not too happy, part of the guage pod is missing.

Theres a rounded part that sits over the front top half of the gauges thats missing :( Really angry as it means im going to have to buy another pod just for that one small part..

the part your missing is a rubber section and isint available from ford on its own without the pod unfortunitly mate,

have you raised a dispute on ebay because the item purchased was not the item in the image,

and try to get a refund or partial refund,

if its a breakers you purchased from then they should be able to supply you with the additional part at a later date with no additional cost.

I had the same same problem with my dash compartment catch.

Replace the Push Latch - about £5 from SouthCo

E4 Touch latches