Skip to content
View in the app

A better way to browse. Learn more.
Ford Owners Club - Ford Forums

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.



Join the Independent Ford Owners' Club

Our community has been built by enthusiasts, for enthusiasts, and proudly run by Ford owners' for over 18 years. As an independent, non-official club, everything you’ll find here, advice, support, and opinions, comes directly from members with genuine Ford ownership experience.

Join our friendly community... it's Free!

 

Xenon Parts Requirement

k13r4n
k13r4n
in Ford Focus Club

Featured Replies

sorry the control module you will need to source, what you are looking for up in the footwell is a socket to plug the box into.

An easier way to find out if you have it would be to remove the A pillar plastic trim, which leaves a gap for you to look down behind the air blower (drivers side) and you should either see not alot or a grey coloured foam tape covering an electrical socket. I will post some pics tomorrow

Also if you look on the inside of the bumpers, the holes are already marked out, just like the rear parking sensors are in the back bumper

  • Quote


    what you are looking for up in the footwell is a socket to plug the box into.

    An easier way to find out if you have it would be to remove the A pillar plastic trim, which leaves a gap for you to look down behind the air blower (drivers side) and you should either see not alot or a grey coloured foam tape covering an electrical socket. I will post some pics tomorrow

    would this be on my mk2 ghia too?

  • Quote

    To be fair mate, from what was said above it seems ford have a mind of their own when it comes to the different wiring looms so all I would say is check it out. If you have the wire in the engine bay for the front levelling sensor it would be silly if you didn't have this connector. All depends on what Ford decided to do.

    I will try and get some pics tomorrow to help you all find the right bits :)

  • Quote
    • Author

    Ok cheers in advance haz and found the four way connector beside the bonnet holder

  • Quote
    • Author

    Wire beside water bottle is pic 1 pic 2 is the wire to drivers light it has 10 wires going in

    post-32783-0-70640600-1350580169_thumb.j

    post-32783-0-51345600-1350580203_thumb.j

  • Quote
    • Author

    Erm this is under the light behind the arch bit beside my water bottle and think this is the wiring loom code rb2004

  • Quote
    • Author

    Erm this is under the light behind the arch bit beside my water bottle and think this is the wiring loom code rb2004

    post-32783-0-25899900-1350582913_thumb.j

    post-32783-0-62906200-1350582943_thumb.j

  • Quote

    Yeah that's the socket for the washer bottle. If that has about 4 or more wires going to it then it should work with the ST front bumper washers too.

    Looks like your wiring is the same as mine then :)

  • Quote

    I'll have to check this tomorrow

  • Quote
    • Author

    Ok so all I would need to do is source parts and wire it all up

  • Quote

    • Latest Deals

    Ford UK Shop for genuine Ford parts & accessories

    Disclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via the club

    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.

    Guest
    Reply to this topic...
    Go to topic listing

    The "Digestive"

    • The Digestive Forum Roundup (24th May - 31st May 2026)

      Steve ·
      The Digestive Forum Roundup (24th May - 31st May 2026) We hope this email finds you well and enjoying your week. As always, our forum has been buzzing with activity, so we’ve compiled the highlights for you. Plenty of interesting discussions are taking place, especially around the Ford Focus and Fiesta models. Starting off with the Focus, many members have been discussing issues with the Emergency Call System, particularly in the Mk4 model. PLB raised concerns about persistent malfunctions, a se
      Steve
      Steve
      • 233 views





    Background Picker
    Customize Layout

    Account

    Navigation

    Search

    Search

    Configure browser push notifications
    Chrome (Android)
    1. Tap the lock icon next to the address bar.
    2. Tap Permissions → Notifications.
    3. Adjust your preference.
    Chrome (Desktop)
    1. Click the padlock icon in the address bar.
    2. Select Site settings.
    3. Find Notifications and adjust your preference.