Jump to content
Do Not Sell My Personal Information

Xr4I 2.8 A Reg


Vibe
 Share

Recommended Posts

Hello all, I'm new here to these forums, joined in the look out for stuff for my wife's mk7 fiesta and noticed you have sub forums.

My grandad has a A reg Sierra xr4i 2.8 in his garage, been dry stored for 10 year, however it's also not been ran for those 10 years, my question is, what would I be looking at doing to get this running again? Also I recall it running on 4 star, which isn't available anymore or atleast no where local to me, what's my options fuel wise should I get it back on the road?

Regards Vibe

Link to comment
Share on other sites


Not much, sometimes the Valve seats can wear out as the lead protected them but tbh the old Fords are all you see on the roads from these days.

Only difference in the fuel otherwise was the octane rating, 4* was near 100RON closest you can get is 99 and it's expensive, but give it a try, the tank will most likely need to be drained and aired out, fuel goes stagnant after a while and if it wasn't filled at the time probably has lots of condensation in it, so give it a drain, air it out, new oil and plugs etc, new battery and see if it starts.

be warned though, it's an 80s Ford, the suspension has probably corroded through the floor by now, shocks will be knackered and the discs will be rotten and brake lines will need replacing, but if you take on a little project you'd have a very very rare car there, easy £10k's plus worth if it's in good nick, rust free and runs.

Link to comment
Share on other sites

Thanks for the response, doesn't sound like too much of a job

Link to comment
Share on other sites

That sent half way through typing haha, I believe the shockers have already gone as this was the reason it went into storage as his back went and was unable to doe work, 10k though?! That's a lot ha ha

Link to comment
Share on other sites

DON'T try to run it on super unleaded, if it is designed to run on leaded get some additive to put in the tank. If it hasn't been started for ten years I would turn the engine by hand first, if you plan on fixing it up. It is possible it is seized, and trying to start it could wreck the engine. By turning it by hand, it can be loosened up without expecting it to go straight to 1000 rpm.

Otherwise, like mentioned before, give it a visual inspection, check all perishables, change all fluids, check for rust, etc. I would be tempted to see if you can get it started with care, if it is capable of running under it's own steam, if it starts, stops and drives fine and hasn't rusted in half get it in for an MOT and they will soon tell you what needs doing!

Also, get some photos up... Would love to see it

For your info, a scruffy one
http://www.ebay.co.uk/itm/like/231537076136?clk_rvr_id=817482363980&item=231537076136&lgeo=1&vectorid=229508&rmvSB=true

A pristine one:
http://www.ebay.co.uk/itm/like/281626162583?clk_rvr_id=817501208203&item=281626162583&lgeo=1&vectorid=229508&rmvSB=true

(Not affiliated with sellers)

Link to comment
Share on other sites


Well it's not pristine but was in great condition when he stored it, had a Shell replacement few years before going into garage assell, it's the silvery grey in colour with red pin stripe, just trying to think of its bottom half is black or colour coded

Link to comment
Share on other sites

hope you get it up and running, I had one back it the day will try and find a picture of it and post it up

Link to comment
Share on other sites

Yeah me too, only problem is getting it to me and finding somewhere to store it atm

Link to comment
Share on other sites

  • 5 years later...

I AM LOOKING FOR XR4I ,  FOR SALE , PLEASE EMAIL ME , sydsardar@hotmail.com 

Link to comment
Share on other sites

  • 5 months later...

Hi,Just looking  for exhaust  for xr4i  if anybody knows of any out  ter.Also my xr4i  once started  and gets warm. Wont start again till  it cools abit.Does anybody  know what this could  be?

Link to comment
Share on other sites

I ran a couple of 2.8i Capris in the '80s and can remember something about the cold start injector circuit, and unplugging the electrical connector but not any details.

Try the XROC web site where there will be members with this engine

http://www.xrstyle.co.uk/forums/index.php

or the Capri Club

 

Cannot help with exhaust.

Link to comment
Share on other sites

  • 3 weeks later...
On 1/23/2021 at 8:23 PM, Peter kelly said:

Hi,Just looking  for exhaust  for xr4i  if anybody knows of any out  ter.Also my xr4i  once started  and gets warm. Wont start again till  it cools abit.Does anybody  know what this could  be?

New or old exhaust 

Link to comment
Share on other sites

  • 1 month later...

Is there any other rad to fit Sierra xr4i V6 other than original,or known were to buy a alloy rad?

Link to comment
Share on other sites

  • 4 months later...

Hi guys does anyone know where I can buy a exhaust for a 1983 Sierra xr4i 2.8i ?

Link to comment
Share on other sites


Latest Deals

Ford UK Shop for genuine Ford parts & accessories

Disclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via the club

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share






×
×
  • Create New...

Forums


News


Membership