Ford Fiesta st mk7 remapping

[ledzz10]

Hey guys this is going to be my last post before getting my st molded
Read a lot of posts about this and still not sure
Was looking at getting a ollins performane p2e for ages

Uprated Actuator
Air tech stage 1
Itg induction
Looking to keep exhaust standard

Are there any other options as read the revo maps or maxd2r maps make more of an explosive throw back in seat difference
However these seem to require an aftermarket exhaust
And this needs to be standard as getting older and like the vehicle to seem standard for a sleeper
Thanks
Much love to any responses

[Luke4efc]

The reason those maps will "make more of an explosive throw back in seat" is down to the fact it utilises the freer-flowing exhaust so can have more power. 

Collins make pretty much the best maps for my car, I'd imagine it's the same for the Fiesta too. Btw the CP-2e still requires a cat-back exhaust lol. 

[ledzz10]

Thank you for responding

Not true though spoke to them over the phone and they said a standard exhaust is more than enough and aftermarket exhausts make little dfferen e

[ledzz10]

1 hour ago, Luke4efc said:

The reason those maps will "make more of an explosive throw back in seat" is down to the fact it utilises the freer-flowing exhaust so can have more power. 

Collins make pretty much the best maps for my car, I'd imagine it's the same for the Fiesta too. Btw the CP-2e still requires a cat-back exhaust lol. 

 

[Luke4efc]

1 hour ago, ledzz10 said:

Thank you for responding

Not true though spoke to them over the phone and they said a standard exhaust is more than enough and aftermarket exhausts make little dfferen e

If aftermarket exhausts make little difference then suppose there's no reason you can't use the REVO or MAXD remaps you stated earlier then 🤷‍♂️.